Special functions
IP5109-Bxxx
 
IP5109-Bxxx | 1-channel incremental encoder interface, 1 MHz
IP5109-Bxxx
Connector
assignment
M12 I/O
connection sockets
Signal status display
Labelling areas
M23 I/O
connection sockets
Power supply
status display:
Box supply (US)
Auxiliary voltage (UP)
Gate/Latch
connection
1 | +24 V DC Us
2 | Gate
3 | GNDs
4 | Latch
5 | Shield
Encoder
connection
1 |
B
2 | +5 V DC
 Sensor
3 | C
4 | C
5 | A
6 | A
7 | Status
8 | B
9 | n.c.
10 | GNDs
11 | GNDs
12 | +5 V DC
 Sensor
1 | + 24 V DC Us
2 | + 24 V DC UP
3 | GNDs
4 | GNDP

IP5109-Bxxx | 1-channel incremental encoder interface, 1 MHz

The IP5109 module is an interface for the direct connection of incremental encoders with differential inputs (RS485) or with single inputs. A 16 bit counter with a quadrature decoder and a 16 bit latch for the zero pulse can be read, set or enabled. The inputs can optionally be used as complementary or as single inputs. Incremental encoders with alarm outputs can be connected at the interface’s status input. Interval measurement with a resolution of 200 ns is possible. The gate input allows the counter to be halted (high = stop). The value is read with a rising edge at the latch input.

Technical data IP5109-Bxxx
Connection technology encoder/sensor: M23 connector with outer thread, 12-pin,
gate/latch: M12, screw type
Number of channels 1
Connection encoder/sensor M23 connector with outer thread, 12-pin
Nominal voltage 24 V DC (-15 %/+20 %)
Signal input difference signal (RS485)
Gate/latch connection M12, screw type
Encoder supply 5 V DC
Sensor supply from control voltage, max. 0.5 A total, short-circuit-proof
Counter 16 bit, binary
Limit frequency 1 MHz (with 4-fold evaluation)
Quadrature decoder 1-, 2-, or 4-fold evaluation
Zero-pulse latch 16 bit
Resolution 16 bit binary value
Commands read, set, enable
Data transfer rates
Power supply connection feed: 1 x M8 male socket, 4-pin; downstream connection: 1 x M8 female socket, 4-pin
Current consumption from US (without sensor current) see documentation
Bit width in the process image input/output: 2 x 16 bit data + 1 x 8 bit control/status
Electrical isolation depends on the bus system
Operating/storage temperature 0…+55 °C/-25…+85 °C
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 65/66/67 (conforms to EN 60529)/variable
Approvals CE, UL