2-channel relay output terminal 125 V AC/30 V DC, potential-free change-over, no power contacts EL2612
Signal LED 2
Signal LED 1 
Power contact PE
Output 1
Output 2
PE
Top view 
Contact assembly 

EL2612 | 2-channel relay output terminal 125 V AC/30 V DC, potential-free change-over, no power contacts

The EL2612 output terminal has two relays each of which has a change-over contact. The EtherCAT Terminal indicates its signal state by means of light emitting diodes. The EL2612 has potential-free contacts. The power contacts are not looped through.

Technical data EL2612 | ES2612
Connection technology relay output
Number of outputs 2 x change-over
Nominal voltage 125 V AC/30 V DC
Load type ohmic
Distributed clocks
Ohmic switching current 0.5 A AC/2 A DC per channel
Inductive switching current no data
Minimum permitted load 10 µA at 10 mV DC with intact contact coating
Lamp test, electronic ballast
Current consumption E-bus typ. 150 mA
Electrical isolation 500 V (E-bus/field potential)
Current consumption power contacts
Bit width in the process image 2 outputs
Operating cycles mech. (min.) 1 x 108
Operating cycles electr. (min.) 2 x 105 (1 A/30 V DC)
Configuration no address or configuration setting
Special features signal relay
Weight approx. 50 g
Operating/storage temperature 0…+55 °C/-25…+85 °C
Relative humidity 95 %, no condensation
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 20/variable
Pluggable wiring for all ESxxxx terminals
Approvals CE, UL