EtherCAT extension EK1110
 EtherCAT signal output
 Link/Act
Run LED
extended temperature range
extended shock and vibration range

EK1110 | EtherCAT extension

Like the E-bus end terminal, the EK1110 EtherCAT extension is connected to the end of the EtherCAT Terminal block. The terminal offers the option of connecting an Ethernet cable with RJ45 connector, thereby extending the EtherCAT strand electrically isolated by up to 100 m. In the EK1110 terminal, the E-bus signals are converted on the fly to 100BASE-TX Ethernet signal representation. Power supply to the EK1110 electronics is via the E-bus. No parameterisation or configuration tasks are required.

Technical data EK1110
Task within EtherCAT system conversion of the E-bus signals to 100BASE-TX Ethernet for extension of the EtherCAT network
Data transfer medium Ethernet/EtherCAT cable (min. Cat.5), shielded
Distance between stations 100 m (100BASE-TX)
Protocol any EtherCAT protocol
Delay approx. 1 µs
Data transfer rates 100 Mbaud
Configuration not required
Bus interface 1 x RJ45
Power supply from E-bus
Current consumption E-bus typ. 130 mA
Electrical isolation 500 V (supply voltage/Ethernet)
Weight approx. 50 g
Operating/storage temperature -25…+60 °C/-40…+85 °C
Relative humidity 95 %, no condensation
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 20/variable
Approvals CE, UL, Ex
Accessories  
Cordsets cordsets and connectors
System  
EtherCAT For further EtherCAT products please see the system overview