Adapter terminal for KL8001 power terminals KL9060
Signal output
terminal bus
+24 V
0 V
PE
Top view 

KL9060 | Adapter terminal for KL8001 power terminals

The KL9060 adapter terminal is attached to the end of the Bus Terminal block in the same way as the standard terminal KL9010. The block is terminated with the KL9060 and provides the opportunity to connect one or more power terminals of the KL8001 series. In the KL9060 the K-bus signals are fed into a ribbon cable together with the 24 V DC for the power contacts.

Power for the electronics of the KL9060 and also for the internal electronics of the subsequent KL8001 power terminals is provided via the K-bus. The power contacts and the associated connection points are electrically isolated and fed to the output stages of the power terminal. This connection is short-circuit-proof and capable of bearing up to 1 A. Supply voltage feeding from one power module to the next can be achieved without any additional wiring. The KL9060 forms a properly working unit together with at least one KL8001. No further parameterising or configuration work on the KL9060 is necessary apart from plugging-in the K-bus extension cable. All diagnostic and commissioning tasks relate directly to the power terminal.

Technical data KL9060
Number of power terminals up to 10 KL8001
Current load ≤ 10 A
Power LED
Defect LED
Type of connection 1 x 10-pin ribbon cable connector
Distance between stations
Starting current
Current consumpt. K-bus
Current supply K-bus
Power contacts 24 V DC (-15 %/+20 %)/1.4 A max., short-circuit-proof
Nominal voltage 24 V DC (-15 %/+20 %)
Electrical isolation 500 V (power contact/supply voltage/K-bus)
Configuration possibility none, automatic
PE contact yes
Shield connection
Bit width in the process image
Electrical connection to DIN rail
Special features connection to KL8001 via 20-pin flat ribbon plug
Weight approx. 65 g
Operating/storage temperature 0…+55 °C/-25…+85 °C
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 20/variable
Approvals CE
Accessories  
KL8001 Power terminal for Siemens contactor series Sirius 3R
ZK1010-8080-3003 ribbon cable for bus connection between two power terminals KL8001, length 0.03 m, included in scope of supply of KL8001
ZK1010-8080-3005 ribbon cable for bus connection between two power terminals KL8001 for reversing contactor connection, length 0.05 m
ZK1010-8080-3010 ribbon cable for bus connection between the KL9060 and the KL8001, length 0.1 m, included in scope of supply of KL9060
ZS1010-1610 Plug for exposed bus connection of the KL8001, included in scope of supply of KL9060